Designed Specifically For Drag Racing
Rear brake kit for OEM 1967-1980 Small GM housing ends
Fits Strange axles using 1/2″ or 5/8″ screw-in wheel studs
Compatible with Strange C-clip eliminator kits A1030 or A1034*
Brake offset = 2.832″
* Must specify if using Strange A1032, A1033, or A1100 eliminator kit
This Strange rear brake kit includes:
Forged One Piece Slotted Steel Rotors
– Superior strength without the concerns of bolts loosening or hats cracking
– Slots improve air flow, assist in warpage prevention, and reduce weight
Four Piston Aluminum Directional Calipers with Stainless Steel Pistons
– Aluminum bodies drastically reduce weight
– Pistons are 1.625″ & 1.750″ to vary pressure on the pads decreasing pad taper
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise
Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance
Modified Inner C-clip Eliminator Halves with Seals & Gaskets
– No pressing required allows for easy installation
– Maintains same wheel to wheel width
– Contains modified half for A1030 / A1034 unless specified otherwise
Hard Metallic Brake Pads
– Provides high resistance to brake fade
– Recommended for vehicles going over 150 MPH in the 1/4 mile
– Maintains decent starting-line cold holding capabilities
– May leave pad residue on rotors that requires removal when pads are changed
Need More Wheel Clearance?
Low Profile Caliper Option…………… OPRB10
Want Billet Calipers?
Red or Black Billet Caliper Option… OPRB07
Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings