Strange Pro Series II Dual Rear Brake Kit For Big Ford / Early Big Ford Housing Ends With 2 Pc Slotted Rotors, Four Piston Calipers & Soft Metallic Pads


Part Number: B1708WCD2

Designed Specifically For Drag Racing
Dual rear brake kit for Big Ford / Early Big Ford housing ends
Brake offset = 2.332″

Note: Dual rear kits for Big Ford housing ends with 2.500″ brake offset are not offered

This Strange rear brake kit includes:
Two Piece Floating Slotted Steel Rotors
– Floating design isolates rotor from hat to allow rotor growth and minimize distortion
– Slots improve air flow, assist in warpage prevention, and reduce weight
– Anti-rattle clips reduce brake pad vibration and noise

Four Piston Aluminum Directional Calipers with Stainless Steel Pistons
– Aluminum bodies drastically reduce weight
– Pistons are 1.625″ & 1.750″ to vary pressure on the pads decreasing pad taper
– Stainless steel pistons are corrosion resistant

Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance

Housing End Stud Kit
– Provides additional components that are not supplied in most aftermarket systems

Soft Metallic Brake Pads
– Provides the best starting-line cold holding power
– Recommended for vehicles going 150 MPH or less in the 1/4 mile

Need More Wheel Clearance?
Low Profile Caliper Option…………… OPRB10

Want Billet Calipers?
Red or Black Billet Caliper Option… OPRB07

With Other Brake Pads
Hard metallic….. B1708WCDM2

Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings


Dual rear brake kit for Big Ford / Early Big Ford ends with 2 pc steel rotors & soft metallic pads

Parts List and Installation Guide pdf File

You may also like…

Recently viewed products

  • Fill Plug Assembly

    PN : H1116
    Add to cart
  • U1613-4

    4 Magnet Pick-Up Collar For Strange 9″ Ford Premium 28 Spline Yokes

    PN : U1613-4
    Add to cart
  • OPRF05

    Upgrade – For New Ford 9″ Center Section From Small Stem Pro to Large Stem Pro Gear

    PN : OPRF05
    Read more
  • Axle Bearing With Locking Collar – Each For 3.150″ ID Housing End Fits Axles With 1.7735″ Bearing Area

    PN : A1019
    Add to cart