Designed Specifically For Drag Racing
Refer to the clearance diagrams shown on this page
9 1/2″ / 10″ Gears
Check the ring gear clearance diagrams
10″ gear would require a spacer kit – N1950HK
Application
Pro Mod
Alcohol Funny Car
Top Dragster
Drag Radial
Outlaw 632
Radial vs The World
Radical high horsepower vehicles
Additional Parts Required
Strange HD 40 spline spool
10″ Pro gear set
35 spline yoke or coupler
Gasket
Includes
Ultra Case – N1912
• 3.812″ bore
• 206-T4 aluminum
• Extra large oil channel
• Critical areas heavily reinforced
• Billet aluminum main caps
• Solid steel adjuster nuts
• Designed & machined by Strange
• Cast in the USA
Tapered / Ball Support – N1953A
• Billet 6061-T6511 aluminum
• Drilled & tapped for 5/16″ & 3/8″ pick-up sensors
• Clear anodized finish
Installation Parts
• Front pinion bearing & race
• Ceramic angular contact low friction rear pinion bearing
• Two piece adjustable preload spacer
• Rear bearing spacer
• Pinion depth shim kit
• Support bolts, washers, and O-ring
• Low friction pinion seal
• Pinion washer & locking nut
• Oversize tail bearing with retainer plate and screws
• Side bearings and races
• ARP 1/2″ ring gear bolts
Related
HD 40 spline spool – D2002
Load bolt (Not for lightened gears) – N1910H
Yoke / Coupler – U1604 / U3629
Gasket – H1111 / H1111S