Designed Specifically For Drag Racing
Rear brake kit for OEM Large GM 12 bolt housing ends
Fits Strange axles using 1/2″ or 5/8″ screw-in wheel studs
Compatible with Strange C-clip eliminator kits A1031 & A1031Z
Brake offset = 2.832″
This Strange rear brake kit includes:
Forged One Piece Slotted Steel Rotors
– Superior strength without the concerns of bolts loosening or hats cracking
– Slots improve air flow, assist in warpage prevention, and reduce weight
Four Piston Aluminum Directional Calipers with Stainless Steel Pistons
– Aluminum bodies drastically reduce weight
– Pistons are 1.625″ & 1.750″ to vary pressure on the pads decreasing pad taper
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise
Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance
Modified Inner C-clip Eliminator Halves with Seals
– No pressing required allows for easy installation
– Maintains same wheel to wheel width
– Contains modified half for A1031 / A1031Z
Soft Metallic Brake Pads
– Provides the best starting-line cold holding power
– Recommended for vehicles going 150 MPH or less in the 1/4 mile
Need More Wheel Clearance?
Low Profile Caliper Option…………… OPRB10
Want Billet Calipers?
Red or Black Billet Caliper Option… OPRB07
With Other Brake Pads
High Temp metallic… B1717WCH
Hard metallic….. B1717WCM
Note
Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings
