Strange S-Series Rear Brake Kit                                                                           For OEM Small GM Ends with Strange Eliminator Kit                                       With Solid Rotors, Four Piston Calipers & Soft Metallic Pads

/, Drag Race, Brake Kits / Components, S-Series Rear Brake Kits, GM, GM, S-Series Steel Rear Brake Kits/

Strange S-Series Rear Brake Kit                                                                           For OEM Small GM Ends with Strange Eliminator Kit                                       With Solid Rotors, Four Piston Calipers & Soft Metallic Pads

Strange S-Series Rear Brake Kit                                                                           For OEM Small GM Ends with Strange Eliminator Kit                                       With Solid Rotors, Four Piston Calipers & Soft Metallic Pads

$469.00

Part Number: B6716WC

Designed Specifically For Drag Racing

Application
Rear brake kit for OEM 1967-1980 Small GM housing ends
Compatible only with Strange C-clip eliminator kits A1030 or A1034*
Brake offset = 2.832″
Maximum axle flange OD = 6.245″

* Must specify if using Strange A1032, A1033, or A1100 eliminator kit

Note
Rotor is centered by the wheel studs
Center hole is 3.250″ to clear all common brake registers

Kit Includes

Forged One Piece Steel Rotors – B2790
– Superior strength without the concerns of bolts loosening or hats cracking
– .430″ thickness significantly reduces weight over factory rotors
– Accepts 1/2″ & 5/8″ stud kits in 4 1/2″, 4 3/4″, & 5″ bolt circles

Four Piston Aluminum Calipers with Stainless Steel Pistons – B5001
– Aluminum bodies drastically reduce weight
– Pistons are 1.750″ to provide exceptional clamping force
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise

Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance

Modified Inner C-clip Eliminator Halves with Seals & Gaskets
– No pressing required allows for easy installation
– Maintains same wheel to wheel width
– Contains modified half for A1030 / A1034 unless specified otherwise

Soft Metallic Brake Pads – B5010
– Provides the best starting-line cold holding power
– Recommended for vehicles going 150 MPH or less in the 1/4 mile

Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings

Description

S-Series Drag race brake kit / OEM Small GM end

Additional information

Weight 32.65 lbs