Strange Pro Series II Rear Brake Kit                                                                 For OEM Small GM Ends with Strange Eliminator Kit                                     With 2 Pc Slotted Rotors, Four Piston Calipers & High Heat Metallic Pads

/, Drag Race, Pro 2 pc Steel Rear Brake Kits, Make / Model, Make / Model, GM, GM, Brake Kits / Components, Pro Series Steel Rear Brake Kits/

Strange Pro Series II Rear Brake Kit                                                                 For OEM Small GM Ends with Strange Eliminator Kit                                     With 2 Pc Slotted Rotors, Four Piston Calipers & High Heat Metallic Pads

Strange Pro Series II Rear Brake Kit                                                                 For OEM Small GM Ends with Strange Eliminator Kit                                     With 2 Pc Slotted Rotors, Four Piston Calipers & High Heat Metallic Pads

$695.00

Part Number: B1716WCH2

Rear brake kit for OEM 1967-1980 Small GM housing ends
Fits Strange axles using 1/2″ or 5/8″ screw-in wheel studs
Compatible with Strange C-clip eliminator kits A1030 or A1034*
Brake offset = 2.832″

* Must specify if using Strange A1032, A1033, or A1100 eliminator kit

This Strange rear brake kit includes:

Two Piece Floating Slotted Steel Rotors
– Floating design isolates rotor from hat to allow rotor growth and minimize distortion
– Slots improve air flow, assist in warpage prevention, and reduce weight

Four Piston Aluminum Directional Calipers with Stainless Steel Pistons
– Aluminum bodies drastically reduce weight
– Pistons are 1.625″ & 1.750″ to vary pressure on the pads decreasing pad taper
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise

Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance

Modified Inner C-clip Eliminator Halves with Seals & Gaskets
– No pressing required allows for easy installation
– Maintains same wheel to wheel width
– Contains modified half for A1030 / A1034 unless specified otherwise

High Heat Metallic Brake Pads
– Provides the highest resistance to brake fade
– Recommended for vehicles going over 150 MPH in the 1/4 mile
– Pad residue on rotor surface dramatically reduced compared to hard metallic pads
– Not for vehicles requiring starting-line cold holding capabilities

Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings

Description

Rear brake kit for 67-80 OEM small GM ends with 2 pc steel rotors & high heat pads

Additional information

Weight 27.2 lbs

You may also like…