Designed Specifically For Drag Racing
Rear brake kit for Big Ford housing ends
Brake offset = 2.332″
Note: For Big Ford housing ends with 2.500″ brake offset- See B1707WCH2
This Strange rear brake kit includes:
Two Piece Floating Slotted Steel Rotors
– Floating design isolates rotor from hat to allow rotor growth and minimize distortion
– Slots improve air flow, assist in warpage prevention, and reduce weight
Four Piston Aluminum Directional Calipers with Stainless Steel Pistons
– Aluminum bodies drastically reduce weight
– Pistons are 1.625″ & 1.750″ to vary pressure on the pads decreasing pad taper
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise
Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance
Housing End Stud Kit
– Provides additional components that are not supplied in most aftermarket systems
High Temp Metallic Brake Pads
– Provides the highest resistance to brake fade
– Recommended for vehicles going over 150 MPH in the 1/4 mile
– Pad residue on rotor surface dramatically reduced compared to hard metallic pads
– Not for vehicles requiring starting-line cold holding capabilities
Need More Wheel Clearance?
Low Profile Caliper Option…………… OPRB10
Want Billet Calipers?
Red or Black Billet Caliper Option… OPRB07
Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings